Program petsafe collar

If the collar beeps or the test light tool illuminates, the battery and collar are working. Secondly, how do I test my PetSafe transmitter? Insert the two ends of the test loop wire into the two boundary wire terminals on the transmitter. Lay test wire in a loop. Turn the boundary width control knob to 10 and then back to 5. Place the test light tool contacts on the contact points of the receiver collar. Remove the receiver collar from your pet.

Remove the battery from the receiver collar. Discharge all power by holding the correction level button down until the LED is no longer illuminated. Take the receiver collar , use the test light tool or listening to the collar for the beeping.

If you have started to see a red flashing light on your pet's Computer Collar unit, your Power Cap battery may need to be replaced. Your fence will still work, but if your power goes out, the system will no longer be operational until power is restored. How do I re-synchronize my wireless system? At the transmitter, move the boundary switch from the low to the high position. Slowly adjust the boundary control dial up to 8, down to 1 and then back to the 4 position.

How do you test a barking collar? The unit should be within inches of your mouth. How do I fix my PetSafe transmitter? PetSafe RF Transmitter Repair Check that the replaceable fuse on the back of the device is not blown, and if it is replace it.

Make sure your transmitter is the issue by performing the short loop test. The collar needs to be turned off before it can be paired. Confirm it is turned off by checking that the light indicator is not flashing. Note: The light can be hard to see when holding the button on the collar. Press the button on an angle to see the upper half of the button while holding.

Your feedback helps our Customer Care team understand how we can better support customers like you in the future! Privacy Wholesalers Investors Affiliates. Connecting to the server. Skip to Main Content. Home Products. Expand search. Search Search. Place the test light tool contacts on the contact points of the receiver collar. Remove the receiver collar from your pet. Remove the battery from the receiver collar.

Discharge all power by holding the correction level button down until the LED is no longer illuminated. Take the receiver collar , use the test light tool or listening to the collar for the beeping. If you have started to see a red flashing light on your pet's Computer Collar unit, your Power Cap battery may need to be replaced.

Your fence will still work, but if your power goes out, the system will no longer be operational until power is restored. How do I re-synchronize my wireless system? At the transmitter, move the boundary switch from the low to the high position. Slowly adjust the boundary control dial up to 8, down to 1 and then back to the 4 position. How do you test a barking collar?

The unit should be within inches of your mouth. How do I fix my PetSafe transmitter? PetSafe RF Transmitter Repair Check that the replaceable fuse on the back of the device is not blown, and if it is replace it. Make sure your transmitter is the issue by performing the short loop test.

Unplug your transmitter from the AC adapter and disconnect the fence and ground wires. Look for damaged electrical components. Why is my PetSafe collar blinking red? Charging too often can reduce battery life. Charge your receiver collar when the receiver indicator light blinks red.